AIM-ATM Cisco - Network adapter - ATM - T-1/E-1

Width

8.3 cm

Height

0.6 cm

Form Factor

Plug-in module

Additional Information

ATM Edge Connectivity

It requires VWIC-1MFT-T1, VWIC-1MFT-E1, VWIC-2MFT-T1, or VWIC-2MFT-E1 Voice/Wan Inetrface Card

All voice interface cards are supported: FXS, FXO, Analog-DID, E&M, and BRI

The AIM-ATM supports the following ATM services:

Supports up to four ATM T1/E1 ports per AIM, using two 2-port multiflex T1/E1 VWICs in WIC slots, NM-xFE2W, NM-2W, or NM-HDV

ATM class of service (CoS) features CBR, VBR-nrt, VBR-rt, ABR, and UBR

AAL5: H.323 VoIP, up to four T1/E1 channels of AAL5 (with IMA support)

VoATM-AAL2 (trunked only)

If used in conjunction with a T1/E1 multiflex trunk voice/WAN interface card (VWIC-MFT) for circuit-mode data and frame-mode data over ATM infrastructures

Supports QoS features

Permanent virtual circuit (PVC) and switched virtual circuits (SVC) support, where SVC is for data only

ATM Forum UNI 3.0, UNI 3.1, and UNI 4.0

LAN Emulation 2.0 Client and Server

Per VC queuing for segmentation

Support for up to 1024 AAL5 VCs for data/voice features

Support for up to1024 AAL2 VCs with up to 255 subchannels each for voice per AIM

1-Kbps resolution for sustained cell rate (SCR) and peak cell rate (PCR)

32-Kbps minimum traffic rate

13-bit range for VPI/VCI per interface

Maximum Burst Size (MBS) is up to 255 cells per VC

Dynamic management of the cell scheduler table

Operations and management (OAM) support (F5)

Early Packet Discard

AAL5 reassembly time-outs

AAL2 subcell multiplexing support

Network / Transport Protocol

VoIP

OS Required

Cisco IOS 12.2(2)XA, Cisco IOS 12.2(4)T

Min Operating Temperature

0 °C

Humidity Range Operating

10 - 85%